Deleted
Deleted Member
Posts: 0
|
Decat
Jul 31, 2017 9:37:14 GMT
Post by Deleted on Jul 31, 2017 9:37:14 GMT
When fitting a decat pipe what else is removed, EXUP valve? cables? Can any of these be left in place?
|
|
|
Decat
Jul 31, 2017 10:34:13 GMT
Post by Bogie on Jul 31, 2017 10:34:13 GMT
Valve is removed. You can either hide the cables and leave them or you can take them out and just leave the motor under the seat there and hooked up so it doesn't throw a code.
You also have the option of removing the Exup Motor under the seat and getting a servo buddy to keep from getting a code.
Or even a better option is to have your ECU flashed to allow the exhaust to perform better and remove the Servo Motor without needing a servo buddy. The ECU flash can be programmed to disable the Exup servo.
|
|
|
Post by rmilanovic on Jul 31, 2017 19:51:31 GMT
Bogie, is any difference if flash ECU and leave servo buddy - not disabled exup, and flash ECU and disable Exup?
|
|
|
Decat
Jul 31, 2017 20:48:01 GMT
via mobile
Post by Bogie on Jul 31, 2017 20:48:01 GMT
Nope.
|
|
|
Post by rmilanovic on Aug 1, 2017 5:43:20 GMT
Thanks. I saw that FT ECU Active Tune have lambda controller and cable for Bosch wideband sensor... than this is tottaly different approach of flashing, because they allow computer to use this info and depend of them.. I supposse that this is maybe better way to flash bike.
|
|
|
Decat
Aug 1, 2017 18:06:58 GMT
Post by rizla on Aug 1, 2017 18:06:58 GMT
I have just installed a Leo Vince decat on my SP today. Exhaust valve cables removed, but have left the servo in place and plugged in until I get the woolich reflash done. Whole job took no more than an hour. First start up video. youtu.be/Zflv3f4EwjY
|
|