|
Post by mtrider on Apr 21, 2020 18:30:23 GMT
Hello all. anybody having experience with Powervision 3 and the MT10?
|
|
|
Post by mtrider on Apr 30, 2020 6:02:01 GMT
No one???
|
|
|
Post by charwood23 on Apr 30, 2020 9:02:11 GMT
No. Given the cost of a bench flash using the well established and flexibility of Woolich 99% of is go down this route or dyno using the same.
The Woolich flash is so established that tuners have a huge library of almost every configuration and you can smooth out the off throttle harshness, turn on and off the AIS and EXUP etc.
The power vision if I'm it mistaken basically alters the fuel mapping with the only advantage over the PCV being it now maps the closed loop part. Plus it seems expensive and a small library of maps to use.
Bench flash is £225 as a comparison.
|
|
|
Post by mtrider on Apr 30, 2020 15:59:35 GMT
To me it looks like the PV3 is very intuitiv and easy to use. Problem is, as mentioned, the lack of accessible files. In desciptions for tunes for other bikes, Dynojets files alters all the parameters looked at with other tuners. Where I live, we have a respected tuner, who uses the PV3. But I don’t want to start out with a dyno tune. Unfortunately no one seems to have experience with the few tunes accessible with the PV3. So it might end up with a woolich flash...
|
|