d
New Member
Posts: 3
|
Post by d on May 25, 2019 10:50:09 GMT
Hi All, I fitted the Flashtune single push / pull sensor plus wiring kit to my MT10 three weeks ago and had the ECU remapped at Veloxracing with the blipper function unlocked but the blipper doesn't work. All connections are good and I've circuit tested the system with no fault evident. I've even sent the ECU back to Velox to be remapped again just in case...but the blipper still won't work. Any ideas as I'm getting pi$$ d off with it now. Darryl
|
|
|
Post by theculturalattache on May 25, 2019 19:56:33 GMT
I've no idea about your problem but a good place to start would be on the R1 forum here www.yamahar.co.uk/index.php as velox racing are a sponsoring vendor. r1Mike is the velox guy. You may have to create an account to post on that forum. I had my 07 R1 flashed by velox racing when I had it,didn't have a problem. Hope this helps. Let us know how you get on.
|
|
|
Post by theculturalattache on May 25, 2019 20:02:38 GMT
|
|
d
New Member
Posts: 3
|
Post by d on May 26, 2019 14:51:03 GMT
Thanks for that.
I know Mike at Velox as I've previously had stuff off them for my old '15 R1 and am in communication with him as we speak.
I've got continuity both sides of the push/pull sensor and at the ECU and wiring loom when the shift pedal is used as it should...it just won't blip the throttle to allow the downchange.
|
|