|
Post by Bogie on Mar 3, 2018 19:51:55 GMT
|
|
|
Post by exuptoy on Oct 12, 2018 6:07:48 GMT
Lovely bike!
Do the plates need to be behind the sato hook or is it part of the subframe?
Any chance I can get dimensions of the bracket?
Width, thickness, length and hole centres with bolt size?
I may be able to get some done for a group buy.
|
|
|
Post by exuptoy on Oct 12, 2018 7:17:16 GMT
If anyone else can just measure the hole centres of the pillion pegs for me and bolt size I can get it fleshed out. My mate works in an engineering shop and has done the standard CBR1000RR and the ABS versions.
|
|
|
Post by Bogie on Oct 14, 2018 0:21:55 GMT
Lovely bike! Do the plates need to be behind the sato hook or is it part of the subframe? Any chance I can get dimensions of the bracket? Width, thickness, length and hole centres with bolt size? I may be able to get some done for a group buy. I only used the bracket as spacer since I already had it. All you would need to do is use 4 thick washers behind the hooks. This is needed to move the hooks out just far enough to clear the little body work pieces by the seat. Building plates would just be added cost that cheap washers would solve. Again I had the EVO tech plates on there so I used them. Cheers
|
|
|
Post by exuptoy on Oct 14, 2018 3:19:48 GMT
Cheers Bogie, any chance of a measurement of the bolt centres and bolt sizes when you are next with the bike?
|
|